About Resistor Math
Resistor Math is a small set of calculators for the arithmetic that sits between a parts drawer and a working circuit. It reads the colored bands on through-hole resistors and the printed codes on surface-mount ones, then handles the sums that follow: what a divider puts out, which resistor an LED needs, what two parts in parallel add up to, and how long a capacitor takes to charge through a given resistance. Every tool runs in the browser, needs no sign-up, and keeps working on a phone propped up next to a breadboard.
Why a whole site for resistors
Resistors are the cheapest part on most boards and the one people misread most often. A brown band looks red under a desk lamp, a violet band fades toward grey after a few years in a warm enclosure, and a 5-band part read from the wrong end can come out wildly wrong. A good calculator catches those slips. This one rejects a black first digit, flags a result that isn't a standard stock value, and prints the range a meter should read, so a bad reading stands out. The LED tool goes one step further and rounds its answer up to a value you can actually buy, instead of stopping at a figure no supplier stocks.
The people behind it
The site is an independent, self-funded project. It is not run by a parts distributor or a component maker, so no tool steers you toward a particular brand or shop. The same few people write the formulas, the explanations and the automated checks, which means a reported error lands with someone who can change the code. If links to parts ever appear, they will be labelled as such, and they will never change what a calculator tells you.
Where the numbers come from
Band colors and their digits, multipliers and tolerances follow IEC 60062, the international marking standard. The preferred values (E6, E12, E24 and E96) come from IEC 60063. Surface-mount codes follow the common 3-digit, 4-digit and R-notation schemes plus the EIA-96 table printed on 1% parts. The circuit tools use textbook relationships only: Ohm's law, the power law, the divider ratio, the reciprocal sum for parallel parts and the exponential charge curve of an RC network.
Each formula was worked by hand on known examples before it went live, and the site's automated tests repeat those examples on every change. Yellow, violet, red and gold must still decode as 4.7 kΩ at 5%, a 5 V supply feeding a 2 V LED at 20 mA must still ask for 150 Ω, and ten kilohms with a hundred microfarads must still give a time constant of one second.
What the calculators stay out of
Everything here is written for battery, USB and bench-supply projects at low DC voltages, with input limits that stop at 60 V. The pages do not cover building wiring or anything plugged into the grid, and they do not judge whether a design is sound. A calculated value is a starting point: part tolerance, temperature, the load on a divider and the exact forward voltage of an LED all move the real figure, so the datasheet and a multimeter have the final word.
Spotted a mistake?
If a decoded value disagrees with your meter, a code isn't recognised, or a formula looks off, write to hello@resistormath.com with the inputs you used. Each result has its own link, so pasting the address of the page shows exactly what you saw. Confirmed errors get fixed, and the example that exposed them joins the test suite.